What hardness actually means
HRC measures resistance to indentation. Hard particles such as Cr7C3 resist abrasive cutting, so hardness correlates with abrasive wear resistance. But wear is rarely a single mechanism: abrasion, impact, corrosion and adhesive wear often act together, and raising hardness usually costs toughness and impact resistance.
Three material systems
- High-chromium cast iron: 12%-30% Cr with high carbide content, excellent abrasive resistance, suited to continuous abrasion; impact resistance is modest and casting defects are a risk.
- Overlay composite plate: high-chromium carbide layer metallurgically bonded to a low-carbon steel base — weldable, field-repairable and generally the best value, which is why it dominates current practice.
- Martensitic wear steel (such as NM grades): hardened to martensite, high hardness with better impact behaviour than high-chromium iron, appropriate for moderate wear where machining is needed.
Choose the band by duty
- Continuous fine-particle abrasion (cement and coal grinding): 58-62 HRC, favouring high-chromium overlay with roughly 30% Cr7C3 volume fraction.
- Large lump impact plus wear (crushers, feed chutes): use chromium-bearing wear steel or a lower-hardness tough solution and add structural thickness; pure high-hardness plate chips at the edges here.
- Mixed duty with limited shutdown access: a balanced 60-63 HRC solution that trades abrasion against impact.
Three costs of very high hardness
- Weldability degrades: higher carbon and alloy content demands preheating and controlled cooling, raising installation cost.
- Edge chipping risk: brittle high-hardness layers crack readily from impact at notches.
- Non-linear cost growth: moving from 58 to 63 HRC raises alloy and machining cost noticeably faster than performance improves.
Why "harder is better" fails
A representative failure: a mine fitted 62 HRC plate in a feed chute taking large lump impact, and widespread edge chipping appeared within two months, making repair cost higher than simply switching to an impact-resistant wear steel. The plate grade was not matched to the actual failure mode. Deciding whether the dominant mechanism is wear or impact matters more than consulting a hardness table.
Enquiry and sampling
Send us the duty (material type, particle size, operating temperature), liner dimensions, quantity and required delivery date in one message, and you will receive a comparable quote, a sampling plan and a selection recommendation.
Key parameters at a glance
| Parameter | Value |
|---|---|
| Standard size (mm) | 1400×3400 / 1500×3000 / 2000×3000 |
| Process | Submerged Arc Welding (SAW) |
| Type | Flux-cored wire (FCAW/SAW) |